Buick Regal: Folding Mirrors
Manual Folding Mirrors
.png)
The mirrors can be folded inward toward the vehicle to prevent damage when going through an automatic car wash. Push the mirror outward to return it to the original position.
Heated Mirrors
The vehicle has heated outside mirrors.
.png)
: Press this button on the center
stack to heat the outside mirrors.
Reverse Tilt Mirrors
If equipped with memory seats, the passenger and/or driver mirror tilts to a preselected position when the vehicle is in R (Reverse). This allows the curb to be seen when parallel parking. The mirror(s) return to the original position when:
- The vehicle is shifted out of R (Reverse), or remains in R (Reverse) for about 30 seconds.
- The ignition is turned off.
- The vehicle is driven in R (Reverse) above a set speed.
Turn this feature on or off through vehicle personalization.
READ NEXT:
Interior Mirrors
Interior Rearview Mirrors
Adjust the rearview mirror for a clear
view of the area behind your
vehicle.
If equipped with OnStar, the vehicle
may have three control buttons at
the bottom of the mirror.
Windows
Warning:
Never leave a child, a helpless
adult, or a pet alone in a vehicle,
especially with the windows
closed in warm or hot weather.
They can be overcome by the
extreme heat and suffer
permanent i
Roof
Sunroof
If equipped, the sunroof only
operates when the ignition is on or
in ACC/ACCESSORY, or when
Retained Accessory Power (RAP) is
active.
Sunroof Switch
The vehicle may have one of two
different
SEE MORE:
Securing Child Restraints (With
the Seat Belt in the
Front Seat)
This vehicle has airbags. A rear
seat is a safer place to secure a
forward-facing child restraint. See
Where to Put the Restraint.
In addition, the vehicle has a
passenger sensing system which is
designed to turn off the front
outboard passenger frontal airbag
and knee airbag under certain
conditio
Symptoms - Wiper/Washer Systems
NOTE: The following steps must be completed before using the symptom
tables:
1. Perform Diagnostic System Check - Vehicle , in order to verify that all of
the following conditions are true:
No DTCs are set.
The control modules can communicate via the serial data link.
2. Refer to Wiper/Washer
© 2019-2026 Copyright www.buregal6.com
