Buick Regal Owners & Service Manuals

Buick Regal: Power Door Locks

: Press to unlock the doors.

: Press to unlock the doors.

indicator light in the switch will: Press to lock the doors. The indicator light in the switch will illuminate when activated.

Delayed Locking

This feature delays the locking of the doors until five seconds after all doors are closed.

Delayed locking can only be turned on when Open Door Anti-Lockout has been turned off.

When door lock switch while the door is is pressed on the power door lock switch while the door is open, a chime will sound three times indicating delayed locking is active.

The doors will lock automatically five seconds after all doors are closed. If a door is reopened before that time, the five-second timer will reset when all doors are closed again.

Press again or press  on the RKE on the door lock switch again or press transmitter to lock the doors on the RKE transmitter to lock the doors immediately.

This feature can also be programmed.

Automatic Door Locks

The doors will lock automatically when all doors are closed, the ignition is on, and the vehicle is shifted out of P (Park).

If a vehicle door is unlocked, and then opened and closed, the doors will lock either when your foot is removed from the brake or the vehicle speed becomes faster than 13 km/h (8 mph).

To unlock the doors:

  • Press switch. on a power door lock switch.
  • Shift the transmission into P (Park).

Automatic Door Unlock can be programmed.

    READ NEXT:

     Lockout Protection

    When locking is requested with the driver door open and the vehicle is on or in ACC/ACCESSORY, all the doors will lock and then the driver door will unlock. If the vehicle is off and locking is reque

     Doors

     Liftgate

    Warning: Exhaust gases can enter the vehicle if it is driven with the liftgate or trunk/hatch open, or with any objects that pass through the seal between the body and the trunk/hatch or liftgate. Eng

    SEE MORE:

     Automatic Transmission Flex Plate Replacement

    Special Tools EN-45059 Angle Meter EN-50792 Holding Tool Equivalent regional tools: Special Tools Removal Procedure 1. Remove the transmission. 2. To prevent crankshaft rotation, install the EN-50792 holding tool (2) and starter motor bolts (1) at the starter motor location and engaging the

     Evaporative Emission System Diagnosis

    Special Tools CH-44284-2 Fuel Flapper Door Holder EN-41413-VLV EVAP Service Port Vent Fitting GE-41415-60 Engine Induction System Leak Test Adapter/Capless Fuel Fill Adapter Operating Instructions for the Evaporative Emission System Tester Vehicle Setup WARNING: Refer to Fuel and Evaporative

    © 2019-2025 Copyright www.buregal6.com