Buick Regal: Repair Instructions
READ NEXT:
Inspection Procedure
1.
CONTROL MODULE DTC CHECK - Using a scan tool, perform the Vehicle DTC
Information function - Verify there are no current control module DTCs set. If
any DTC is set, refer to
Calibration (without UGN)
NOTE: Do NOT swap cameras between vehicles, it is not approved and a
VIN
mismatch will occur.
The calibration process for the front view camera system is necessary when a
f
NOTE: Adaptive Cruise Temporarily Unavailable service message may be
displayed if this calibration procedure has to be performed. The radar
may have become misaligned.
After replacing and programming
SEE MORE:
Preliminary Procedures
1. Remove the rear tire and wheel assembly.
2. Shock Absorber Replacement (GNC)Shock Absorber Replacement (GNQ).
CAUTION: Refer to Fastener Caution.
Rear Shock Absorber NutTighten 20 N.m (15 lb ft)
Rear Suspension Mount Upper Cup
Rear Shock Absorber Mount
Rear Shock A
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diagnostic Procedure Instructions provides an overview of each
diagnostic category.
DTC Descriptors
D