Buick Regal: Shifting out of Park
This vehicle is equipped with an electronic shift lock release system.
The shift lock release is designed to prevent movement of the shift lever out of P (Park) unless the ignition is in on and the brake pedal is applied.
The shift lock release is always functional except in the case of an uncharged or low voltage (less than 9-volt) battery.
If the vehicle has an uncharged battery or a battery with low voltage, try charging or jump starting the battery.
To shift out of P (Park):
1. Apply the brake pedal.
2. Turn the ignition on.
3. Press the shift lever button.
4. Move the shift lever to the desired position.
If still unable to shift out of P (Park):
1. Fully release the shift lever button.
2. Hold the brake pedal down and press the shift lever button again.
3. Move the shift lever to the desired position.
If you still cannot move the shift lever from P (Park), consult your dealer or a professional towing service.
Parking over Things That Burn
Warning: Things that can burn could touch hot exhaust parts under the vehicle and ignite. Do not park over papers, leaves, dry grass, or other things that can burn.
Extended Parking
It is best not to park with the vehicle running. If the vehicle is left running, be sure it will not move and there is adequate ventilation.
If the vehicle is left parked and running with the Remote Keyless Entry (RKE) transmitter outside the vehicle, it will turn off after one hour.
If the vehicle is left parked and running with the RKE transmitter inside the vehicle, it will turn off after two hours.
The vehicle could turn off sooner if it is parked on a hill, due to lack of available fuel.
The timer will reset if the vehicle is taken out of P (Park) while it is running.
READ NEXT:
Engine Exhaust
Warning:
Engine exhaust contains carbon
monoxide (CO), which cannot be
seen or smelled. Exposure to CO
can cause unconsciousness and
even death.
Exhaust may enter the vehicle if:
The vehicle idles
Automatic Transmission
The mode or selected gear is shown
in the instrument cluster.
P : This position locks the drive
wheels. It is the best position to use
when starting the engine because
the vehicle cannot move easily
SEE MORE:
Description and Operation
PROPELLER SHAFT DESCRIPTION AND OPERATION
The function of the propeller shaft is to transfer power from the power
transfer unit to the differential clutch. It
consists of three tubes sections; the front tube contains a constant velocity
fixed joint mating to the PTU and a
constant velocity plungi
Wiring Harness Wire Replacement
Removal Procedure
1. Transmission Control Module - Remove - Refer to Transmission Control
Module Replacement.
2. Drain the transmission fluid. Transmission Fluid Drain and Fill.
3. Control Valve Body Cover - Remove - Refer to Control Valve Body Cover
Replacement.
4.
NOTE: Note the position and
