Buick Regal: Special Tools and Equipment
SPECIAL TOOLS
DT-26941
J-26941
Remover

DT-37228
J-37228
Seal Cutter

DT-43911
J-43911
Selector Shaft Seal
Remover

DT-44215
J-44215
Rear Seal Installer

DT-44809
J-44809
Output Shaft Seal
Installer

DT-45124
J-45124
Removal Bridge

DT-45124-9
J-45124-9
Puller Leg

DT-47865
Bearing Remover

DT-48056
Spring Compressor
Bridge

DT-48903
Spring Compressor

DT-49101
Seal Installer

DT-50298
Axle Seal Installer

DT-51721
Bearing Race
Installer

DT-51918
Bearing Race
Installer

DT-51919
Bearing Race
Remover

DT-51920
Clutch Spring
Compressor

EN-21867
J-21867
Pressure Gauge

EN-21867-50
J-21867-50
Transmission Line
Pressure Adapter

EN-45000
J-45000
Seal Remover

GE-6125-1B
J-6125-1B
Slide Hammer with
Adapter

GE-8092
J-8092
Driver Handle

READ NEXT:
FASTENER SPECIFICATIONS
Single Use Non-Threaded Fasteners/Components
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced
with NEW
after removal.
Application
Power Trans
POWER TRANSFER UNIT CASE DISASSEMBLED VIEW
Power Transfer Unit Components
Power Transfer Unit Alignment Sleeve
Power Transfer Unit Face Seal - O-Ring
Power Transfer Unit Case
Power Transfer Unit
SEE MORE:
WARNING: In order to reduce the risk of fire and personal injury
observe the
following items:
Replace all nylon fuel pipes that are nicked, scratched or damaged
during installation, do not attempt to repair the sections of the nylon
fuel pipes
Do not hammer directly on the fuel harness body cl
Removal Procedure
1. Remove the tire and wheel assembly.
WARNING: To prevent personal injury and/or component damage, do not
allow the weight
of the vehicle to load the front wheels, or attempt to operate the vehicle, when
the wheel drive shaft(s) or wheel drive shaft nut(s) are removed. To do so m