Buick Regal: Specifications, Schematic Wiring Diagrams
Specifications
FASTENER SPECIFICATIONS (OFF VEHICLE)
Single Use Non-Threaded Fasteners/Components
NOTE: All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal.
Reusable Threaded Fastener Tightening Specifications
NOTE: All fasteners listed in this table can be reused after removal.
.png)
FASTENER SPECIFICATIONS (ON VEHICLE)
Single Use Non-Threaded Fasteners/Components
NOTE: All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal.
Single Use Threaded Fastener/Component Tightening Specifications
NOTE: All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal.
Reusable Threaded Fastener Tightening Specifications
NOTE: All fasteners listed in this table can be reused after removal.
APPROXIMATE FLUID CAPACITIES
ADHESIVES, FLUIDS, LUBRICANTS, AND SEALERS
TRANSMISSION GENERAL SPECIFICATIONS
RANGE: REFERENCE
Full output, fully engaged = "X".
Zero output, fully disengaged = " - "
Output control engaged = "O"
SHIFT SOLENOID VALVE STATE AND GEAR RATIO
Full output, fully engaged = "X".
Zero output, fully disengaged = " - "
Output control engaged = "O"
N/C = "Normal Close"
TEMPERATURE VERSUS RESISTANCE (B13 TRANSMISSION FLUID TEMPERATURE SENSOR)
TEMPERATURE VERSUS RESISTANCE (Q27 PRESSURE CONTROL SOLENOID VALVE)
TEMPERATURE VERSUS RESISTANCE (Q32 SHIFT SOLENOID VALVE 1)
Schematic Wiring Diagrams
AUTOMATIC TRANSMISSION CONTROLS WIRING SCHEMATICS
Power, Ground, Serial Data, and MIL
Speed and Temperature Sensors, Pressure and Shift Controls (Start/Stop)
Tap Up/Tap Down Switches
READ NEXT:
Component Locator
DISASSEMBLED VIEWS
Case and Associated Parts (1 of 2)
Transmission Control Module Bolt [3x]
Transmission Control Module
Manual Shift Shaft Seal
Transmission Fluid Filler Tube Plug
Transmission
DTC P0218
Diagnostic Instructions
Perform the Diagnostic System Check prior to using this diagnostic
procedure: Refer to Diagnostic System
Check - Vehicle
Review the description of Strategy Based Diagnosi
SEE MORE:
Front Disc Brake Mounting and Hardware Inspection
WARNING: Brake Dust Warning.
1.
Inspect the fluid level in the brake master cylinder reservoir.
2. If the brake fluid level is midway between the maximum-full point and the
minimum allowable level
then no brake fluid needs to be removed from the reservoir before proceeding.
3. If the brake fluid
Engine Oil Life System
The engine oil life system calculates
engine oil life based on vehicle use
and displays the CHANGE ENGINE
OIL SOON message when it is time
to change the engine oil and filter.
The oil life system should be reset
to 100% only following an oil
change.
Resetting the Oil Life System
1. Using the DIC co
