Buick Regal: Diagnostic Information and Procedures
- Brake Rotor Thickness Measurement
- Brake Rotor Assembled Lateral Runout Measurement
- Front Disc Brake Mounting and Hardware Inspection
READ NEXT:
Brake Rotor Thickness Measurement
Special Tools
CH-230 - A Disc Gauge
Equivalent regional tools: Special Tools
WARNING: Refer to Brake Dust Warning.
1. If the inboard friction surface of the brake rotor is not accessible,
reposition
Brake Rotor Assembled Lateral Runout Measurement
Special Tools
GE-571-B Hub and Wheel Runout Gauge
For equivalent regional tools, refer to Special Tools.
WARNING: Refer to Brake Dust Warning.
NOTE:
Brake rotor assembled lateral runout (LRO) exceed
Front Disc Brake Mounting and Hardware Inspection
WARNING: Brake Dust Warning.
1.
Inspect the fluid level in the brake master cylinder reservoir.
2. If the brake fluid level is midway between the maximum-full point and the
minimum allowable level
t
SEE MORE:
Rear Spring Replacement (FWD)
Removal Procedure
1. Remove the rear tire and wheel assembly.
2.
Rear Stabilizer Shaft Link Nut(1) - Remove.
3. Rear Stabilizer Shaft Link Bolt(2) - Remove.
4.
Rear Shock Absorber Nut(1) - Remove.
5. Rear Shock Absorber Bolt(2) - Remove.
DISCARD the bolt.
6. Support the lower control arm.
7
Intake Manifold Cover Replacement
Engine Oil Filler Cap
Intake Manifold Cover Bolt [3x]
Tighten
9 N.m (80 lb in)
Intake Manifold Cover
DRIVE BELT REPLACEMENT
Fig. 1: Drive Belt Routing Diagram (2.0L)
Preliminary Procedure
Front Wheelhouse Liner Replacement (LTG).
Drive Belt
Procedure
Using a suitable tool, slowly
© 2019-2026 Copyright www.buregal6.com
