Buick Regal Owners & Service Manuals

Buick Regal: Power Seats

SPECIFICATIONS

FASTENER TIGHTENING TORQUE SPECIFICATIONS

Reusable Threaded Fastener Tightening Specifications

NOTE: All fasteners listed in this table can be reused after removal.

Power Seats

SCHEMATIC WIRING DIAGRAMS

DRIVER SEAT WIRING SCHEMATICS

Power, Ground, Serial Data and Seat Memory Switch (A45/A44)

Power Seats

Seat Position (AE8+ (A45/A44) )

Power Seats

Seat Position (AE8- (A45/A44) )

Power Seats

Lumbar (AL9)

Power Seats

Lumbar (AVK-AF6)

Power Seats

Power, Ground, Serial Data and Lumbar Support Pump (AVK+AF6)

Power Seats

Lumbar Controls (AVK+AF6)

Power Seats

PASSENGER SEAT WIRING SCHEMATICS

Power, Ground, Serial Data and Seat Memory Switch (A44)

Power Seats

Seat Position (A44)

Power Seats

Power Seats

Lumbar (AT9)

Power Seats

Lumbar (AVU-AKE)

Power Seats

Power, Ground, Serial Data and Lumbar Support Pump (AVU+AKE)

Power Seats

Lumbar Controls (AVU+AKE)

Power Seats

REAR SEAT WIRING SCHEMATICS

Folding Seat Control Switches and Motors (A9U)

Power Seats

READ NEXT:

 Diagnostic Information and Procedures

 DTC B1405, B1825, B2355, B2365, or B2375 (Driver Seat)

Diagnostic Instructions Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Review Strategy Based Diagnosis for an overview of the diagnostic approach. Diag

 DTC B1405, B1825, B2355, B2365, or B2375 (Passenger Seat)

Diagnostic Instructions Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Review Strategy Based Diagnosis for an overview of the diagnostic approach. Diag

SEE MORE:

 Emergency

Emergency Services require an active, OnStar service plan (excludes Basic Plan). With Automatic Crash Response, built-in sensors can automatically alert a specially trained OnStar Advisor who is immediately connected in to the vehicle to help. Press for a priority connection to an OnStar Advisor w

 Transmission Control Lever Knob Replacement

Removal Procedure 1. Set the parking brake. 2. Shift the transmission control lever into Reverse position. 3. Gently release the transmission control lever boot bezel (1) at the front. Unclip 6 retainers (arrows), using a flat bladed tool. 4. Pull the transmission control lever boot bezel up to

© 2019-2026 Copyright www.buregal6.com