Buick Regal: Repair Instructions
READ NEXT:
Park Brake Calibration
The park brakes do not require calibration often. Park brake calibration may
be required after certain
service procedures are performed. Some of these procedures are as follows:
Park brake actuator
Parking Brake Actuator Replacement (GNQ)
Removal Procedure
WARNING: Brake Dust Warning
1. Set the park brake in Service Mode.
Manual Method
Change the transmission gear to neutral or park position.
Press and hold the push button start swi
Description and Operation
ELECTRONIC PARKING BRAKE DESCRIPTION
Vehicles with the electric parking brake have a switch in the center console
or on the dash, which takes
the place of the manual parking brake system, the foot pe
SEE MORE:
Key with Integrated Transmitter Programming (with BTM)
Keys can be programming in various ways using the procedures outlined below.
Using the Replacing
Keys procedure will first erase all the known keys from the vehicle. Any
existing keys and any new keys
will then be programmed. This procedure should be used any time a key is
required to be unlearne
Differential Clutch Oil Inspection
1. Raise and support the vehicle.
2. Clean the area around the rear axle fill plug.
3. Place a drain pan under the vehicle.
4.
Differential Clutch Cover Plug(1) - Remove.
5. Rear Axle Housing Filler Plug Gasket(2) - Remove.
6. Check the fluid level. If necessary, fill the differential to the
© 2019-2026 Copyright www.buregal6.com
