Buick Regal: Repair Instructions
- Brake Pedal Position Sensor Calibration
- Headlamp Bulb Replacement - Left Side (High Beam)
- Headlamp Aiming
- Suspension Position Sensor Calibration
READ NEXT:
Brake Pedal Position Sensor Calibration
Calibration Criteria
NOTE: Do not apply the brake pedal during the brake pedal position
sensor
calibration procedure. Any movement of the brake pedal during this
procedure will cause the calibration
Headlamp Bulb Replacement - Left Side (High Beam)
Preliminary Procedure
Windshield Washer Solvent Container Filler Tube Replacement.
Headlamp Bulb Access Cover
WARNING:
Halogen Bulb Warning.
Procedure
Rotate the cover counterclockwise to remov
Headlamp Aiming
General
Directive 76/756 EEC and ECE-Regulation 48 cover checking and aiming of
headlamps on vehicle.
Correct aiming of headlamps of vehicles should enable optimal road illumination
by the low beam
SEE MORE:
DTC B3060
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diagnostic Procedure Instructions provides an overview of each
diagnostic category.
DTC Descriptor
DT
Special Tools and Equipment
SPECIAL TOOLS
EL - 50334 - 20
Multi-Media
Interface Tester
(MIT)
EL - 50334 - 50
USB Cable and
Adapter Kit
EL-48028
Digital Radio Test
Antenna
EL-49903 - 1
Test Antenna, Navn-
Cell Comn
EL-49903 - 2
Adapter Cable-UHF
RT Angle
EL-49903 - 3A
Combiner Kit, Test
Antenna
EL-50334 - 12
Infotainment
© 2019-2026 Copyright www.buregal6.com
