Power Transfer Unit Case Holding Fixture Installation
Power Transfer Unit Case
Procedure
Always secure with the pivot pin after rotating.
NOTE:
The power transfer unit can be rotated 360 degr
Power Transfer Unit Case Housing Cleaning and Inspection
Preliminary Procedure
Clean the power transfer unit case housing.
The case halves, internal gears and bearings are not serviceable
compon
Power Transfer Unit Idler Gear Shaft Tube and O-ring, Input Shaft Bearing
Race and Shim, and Idler Gear Shaft Bearing
Race and Shim Installation
Power Transfer Unit Idler Gear Shaft Access Tube O-
Removal Procedure
WARNING: Brake Fluid Irritant Warning.
CAUTION: Brake Fluid Effects on Paint and Electrical Components Caution.
1. Place the ignition switch in the OFF position.
2. Apply and release the brake pedal several times until the brake pedal
becomes firm to deplete the
power vacuum brak
Inspection Procedure
1.
CONTROL MODULE DTC CHECK - Using a scan tool, perform the Vehicle DTC
Information function - Verify there are no current control module DTCs set. If
any DTC is set, refer to Diagnostic Trouble Code (DTC) List - Vehicle.
2. Check the alignment of the forward range radar mod