Buick Regal: Specifications, Schematic Wiring Diagrams
SPECIFICATIONS
FASTENER SPECIFICATIONS
Single Use Non-Threaded Fasteners/Components
NOTE: All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal.
Application
Brake Hose Fitting Gasket
Brake Pedal Retainer
Master Cylinder Seal
Single Use Threaded Fastener/Component Tightening Specifications
NOTE: All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal.
.png)
Reusable Threaded Fastener Tightening Specifications
NOTE: All fasteners listed in this table can be reused after removal.
.png)
APPROXIMATE FLUID CAPACITIES
.png)
BRAKE COMPONENT SPECIFICATIONS
.png)
BRAKE SYSTEM SPECIFICATIONS
.png)
ADHESIVES, FLUIDS, LUBRICANTS, AND SEALERS
.png)
SCHEMATIC WIRING DIAGRAMS
HYDRAULIC BRAKE WIRING SCHEMATICS
Hydraulic Brakes
.png)
READ NEXT:
DTC C0126
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Refe
DTC C025E
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Refe
SEE MORE:
SIR Service Precautions
WARNING: If a service procedure indicates that a module is to be
replaced, a new
production unit MUST be ordered from the GM Parts Catalog or certified
supplier. Using a module that has been reset by a 3rd party company is strictly
prohibited. Not using a new production unit may result in improper
Upper Intermediate Steering Shaft Replacement
Removal Procedure
1.
Upper Intermediate Steering Shaft Upper Bolt(1) - Remove.
2. Upper Intermediate Steering Shaft(2)@Steering Column - Separate.
3.
Release the upper intermediate steering shaft boot (1) from the retaining
tabs (2) on the intermediate
steering shaft inner boot.
4.
Slide the u
