Buick Regal: Universal Remote System Operation
Using the Universal Remote System
Press and hold the appropriate Universal Remote system button for at least one-half second. The indicator light will come on while the signal is being transmitted.
Erasing Universal Remote System Buttons
Erase all programmed buttons when vehicle ownership is terminated.
To erase:
1. Press and hold the two outside buttons until the indicator light begins to flash. This should take about 10 seconds.
2. Release both buttons.
Reprogramming a Single Universal Remote System Button
To reprogram any of the system buttons:
1. Press and hold any one of the buttons. Do not release the button.
2. The indicator light will begin to flash after 20 seconds. Without releasing the button, proceed with Step 1 under "Programming the Universal Remote System."
READ NEXT:
Exterior Lamp Controls
The exterior lamp control is on the
instrument panel to the left of the
steering column.
There are four positions.
: Turns the exterior lamps off and
deactivates the AUTO mode. Turn
to again to r
SEE MORE:
Electric Dual Pinion Rack and Pinion Steering Gear Replacement
Removal Procedure
CAUTION: Electrostatic discharge (ESD) can damage many solid-state
electrical
components. ESD susceptible components may or may not be labeled with
the ESD symbol. Handle all electrical components carefully. Use the
following precautions in order to avoid ESD damage:
Touch a met
Lane Change Alert (LCA)
If equipped, the LCA system is a
lane-changing aid that assists
drivers with avoiding lane change
crashes that occur with moving
vehicles in the side blind zone (or
spot) areas or with vehicles rapidly
approaching these areas from behind. The LCA warning display
will light up in the corresponding
ou
