Buick Regal 2018-2025 Service Manual / Accessories and Equipment / Displays and Gauges
Buick Regal: Displays and Gauges
SPECIFICATIONS
FASTENER SPECIFICATIONS
Reusable Threaded Fastener Tightening Specifications
NOTE: All fasteners listed in this table can be reused after removal.
.png)
SCHEMATIC AND WIRING DIAGRAMS
INSTRUMENT CLUSTER WIRING SCHEMATICS
Power, Ground, Serial Data and Gauges
.png)
Indicators (LGX)
.png)
Indicators (LTG)
.png)
Driver Information and Shift Lever Indicator
.png)
HEAD-UP DISPLAY WIRING SCHEMATICS
Head-Up Display (UV6)
.png)
AUDIBLE WARNINGS WIRING SCHEMATICS
Audible Warning
.png)
READ NEXT:
Diagnostic Information and Procedures
DISPLAYS AND GAUGES COMPONENT REPLACEMENT REFERENCE
DTC B0550
Diagnostic Instructions
Perform the Diagnostic System Check prior to using this diagnostic
procedure:Diagnostic System
Check - Vehicle
Review the description of Strategy Based Diagnosis:Strategy
DTC B097D
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diag
SEE MORE:
Wheel Stud Replacement
Special Tools
CH-43631 Ball Joint Separator
Equivalent regional tools:Special Tools
Removal Procedure
1. Front Wheel Bearing and Hub Assembly - Remove.
2.
Use the CH-43631 separator (1) to remove the wheel stud (2) from the flange
on the hub assembly and
DISCARD.
Installation Procedure
1.
Positi
Repair Instructions
BODY WATERLEAK REPAIR
WARNING: If the vehicle interior is exposed to moisture and becomes
soaked up to
the level of the sensing and diagnostic module (SDM), the SDM and SDM
harness connector must be replaced. The SDM could be activated when
powered, which could cause airbag deployment and result i
© 2019-2025 Copyright www.buregal6.com
