Buick Regal Owners & Service Manuals
Buick Regal 2018-2026 Owners Manual / In Brief / Instrument Panel

Buick Regal: Instrument Panel

Instrument Panel Overview

  1. Air Vents
  2. Turn and Lane-Change Signals
  3. Instrument Cluster
    Driver Information Center (DIC) Display
  4. Windshield Wiper/Washer
  5. Hazard Warning Flashers
  6. Light Sensor
  7. Infotainment
  8. Traction Control/Electronic Stability Control
  9. Dual Automatic Climate Control System
  10. Transmitter Pocket
  11. Lane Keep Assist (LKA) Parking Assist Button (If Equipped)
    Selective Ride Control (GS Models Only)
  12. Wireless Charging
  13. Shift Lever
  14. Electric Parking Brake
  15. ENGINE START/STOP Button (Out of View)
  16. Steering Wheel Controls Driver Information Center (DIC) Controls
  17. Horn
  18. Steering Wheel Adjustment
  19. Cruise Control
    Adaptive Cruise Control Forward Collision Alert (FCA) System
    Heated Steering Wheel
  20. Hood Release
  21. Exterior Lamp Controls
  22. Instrument Panel Fuse Block Cover
  23. Data Link Connector (DLC) (Out of View)
  24. Head-Up Display (HUD)
  25. Instrument Panel Illumination Control

    READ NEXT:

     Initial Drive Information

     Stop/Start System

    The vehicle may be equipped with a fuel saving Stop/Start system to shut off the engine and help conserve fuel. When the brakes are applied and the vehicle is at a complete stop, the engine may turn

     Door Locks

    To lock or unlock the door from outside the vehicle: Press or on the Remote Keyless Entry (RKE) transmitter. Use Keyless Access. Use the key. The key lock cylinder is covered with a cap. Fro

    SEE MORE:

     Input Speed Sensor Replacement

    Removal Procedure 1. Control Valve Body - Remove - Refer to Control Valve Body Replacement. 2. Input Speed Sensor Bolt (1) - Remove. 3. Input Speed Sensor (2) - Remove. Installation Procedure 1. Input Speed Sensor (2) - Install. CAUTION: Refer to Fastener Caution. 2. Input Speed Sensor Bolt (1) -

     Camshaft Position Actuator and Camshaft Replacement - Exhaust

    Special Tools EN-50656 Holding Tool EN 50793 Locking Tool For equivalent regional tools, refer to Special Tools. Removal Procedure NOTE: Ensure the engine is properly timed to Top Dead Center (TDC), prior to performing repairs. 1. Remove the camshaft cover. Refer to Camshaft Cover Replacement.

    © 2019-2026 Copyright www.buregal6.com