Buick Regal Owners & Service Manuals
Buick Regal 2018-2026 Service Manual / Steering & Driveline & Axle / Power Steering / Specifications, Schematic and Wiring Diagrams

Buick Regal: Specifications, Schematic and Wiring Diagrams

SPECIFICATIONS

FASTENER SPECIFICATIONS

Single Use Non-Threaded Fasteners/Components

NOTE: All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal.

Application

Power Steering Assist Motor Seal
Steering Gear Belt
Steering Gear Boot Inner Clamp
Steering Gear Bushing

Single Use Threaded Fastener/Component Tightening Specifications

NOTE: All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal.

Power Steering

Reusable Threaded Fastener Tightening Specifications

NOTE: All fasteners listed in this table can be reused after removal.

Power Steering

Power Steering

ADHESIVES, FLUIDS, LUBRICANTS, AND SEALERS

Power Steering

SCHEMATIC AND WIRING DIAGRAMS

POWER STEERING WIRING SCHEMATICS

Power Steering

Power Steering

    READ NEXT:

     Diagnostic Information and Procedures

     DTC C0176

    Diagnostic Instructions Perform the Diagnostic System Check prior to using this diagnostic procedure:Diagnostic System Check - Vehicle Review the description of Strategy Based Diagnosis:Strategy

     DTC C0460

    Diagnostic Instructions Perform the Diagnostic System Check prior to using this diagnostic procedure:Diagnostic System Check - Vehicle Review the description of Strategy Based Diagnosis:Strategy

    SEE MORE:

     Speedometer

    The speedometer shows the vehicle's speed in either kilometers per hour (km/h) or miles per hour (mph). Odometer The odometer shows how far the vehicle has been driven, in either kilometers or miles. Tachometer The tachometer displays the engine speed in revolutions per minute (rpm). For vehicles w

     Camshaft Position Actuator and Camshaft Replacement - Exhaust

    Special Tools EN-50656 Holding Tool EN 50793 Locking Tool For equivalent regional tools, refer to Special Tools. Removal Procedure NOTE: Ensure the engine is properly timed to Top Dead Center (TDC), prior to performing repairs. 1. Remove the camshaft cover. Refer to Camshaft Cover Replacement.

    © 2019-2026 Copyright www.buregal6.com