Buick Regal 2018-2025 Service Manual / Brakes / Antilock Brake System / Specifications, Schematic Wiring Diagrams
Buick Regal: Specifications, Schematic Wiring Diagrams
SPECIFICATIONS
FASTENER SPECIFICATIONS
Reusable Threaded Fastener Tightening Specifications
NOTE: All fasteners listed in this table can be reused after removal.
.png)
SCHEMATIC WIRING DIAGRAMS
ANTILOCK BRAKE SYSTEM WIRING SCHEMATICS
Power, Ground, Serial Data, and Subsystem References
.png)
Wheel Speed Sensors and Traction Control Switch
.png)
READ NEXT:
DTC B2745
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diag
DTC C0035-C0051 (RPO J69)
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diag
SEE MORE:
Repair Instructions
PROPELLER SHAFT REPLACEMENT
Special Tools
DT-51329 Drive Shaft Remover
GE-2619-A Slide Hammer
Equivalent regional tools:Special Tools.
Removal Procedure
1. Raise and support the vehicle.
2.
Floor Panel Tunnel Panel Front Brace(3) - Remove.
3.
Floor Panel Tunnel Panel Rear Brace(2) - Remove.
4
DTC P1176 or P1177
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diagnostic Procedure Instructions provides an overview of each
diagnostic category.
DTC Descriptors
D
© 2019-2025 Copyright www.buregal6.com
