Buick Regal: Transmission Fluid Cooler Outlet Pipe Replacement (9T50 / 9T60)
Removal Procedure
1. Place a suitable container under the vehicle to catch any spilled transmission fluid.
2.
.png)
NOTE: Cover or plug all open transmission fluid cooler pipe connection points to help avoid any accidental contamination or spills.
Transmission Fluid Cooler Outlet Pipe(1)@Radiator - Remove.
3. Front Wheelhouse Liner-Left Side - Remove.
4.
.png)
Transmission Fluid Cooler Outlet Pipe(1)@Radiator - Unclip.
5.
.png)
Transmission Fluid Cooler Outlet Pipe(1)@Transmission - Unclip.
6.
.png)
Transmission Fluid Cooler Outlet Pipe Nut(1)@Transmission - Remove.
7. Transmission Fluid Cooler Outlet Pipe(2)@Transmission - Remove.
8. Remove and DISCARD the sealing washer.(3).
9. Remove the transmission fluid cooler outlet pipe (2) from the vehicle.
Installation Procedure
1. Remove the caps from the fittings and plugs from the holes before installing the transmission fluid cooler pipes.
2. Install the transmission fluid cooler outlet pipe to the vehicle.
3.
.png)
Install a NEW sealing washer.(3) 4. Transmission Fluid Cooler Outlet Pipe(2)@Transmission - Install.
CAUTION: Refer to Fastener Caution.
5. Transmission Fluid Cooler Outlet Pipe Nut(1)@Transmission - Install and tighten22 N.m (16 lb ft).
6.
.png)
Transmission Fluid Cooler Outlet Pipe(1)@Transmission - Engage.
7.
.png)
Transmission Fluid Cooler Outlet Pipe(1)@Radiator - Install.
8. Front Wheelhouse Liner-Left Side - Install.
9.
.png)
Transmission Fluid Cooler Outlet Pipe(1)@Radiator - Install.
10. Fill the transmission to the proper level with NEW transmission fluid.
11. Inspect for transmission fluid leaks.
READ NEXT:
Transmission Fluid Cooler Inlet and Outlet Pipe Replacement (AF50-8)
Removal Procedure
1.
Place a drain pan under the vehicle.
2. Transmission Fluid Cooler Pipe Connector Cap(1)@Radiator - Unclip.
3. Transmission Fluid Cooler Outlet Pipe(2)@Quick Connect Fitting - D
SEE MORE:
Repair Instructions
BODY WATERLEAK REPAIR
WARNING: If the vehicle interior is exposed to moisture and becomes
soaked up to
the level of the sensing and diagnostic module (SDM), the SDM and SDM
harness connector must be replaced. The SDM could be activated when
powered, which could cause airbag deployment and result i
When Should an Airbag
Inflate?
This vehicle is equipped with
airbags.
Airbags are designed to inflate if the
impact exceeds the specific airbag
system's deployment threshold.
Deployment thresholds are used to
predict how severe a crash is likely
to be in time for the airbags to
inflate and help restrain the
occupants. The vehic
