Buick Regal 2018-2026 Service Manual / Transmission / Transmission Cooling System / Repair Instructions
Buick Regal: Repair Instructions
- Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection
- Transmission Fluid Cooler Inlet Pipe Replacement (9T50 / 9T60)
- Transmission Fluid Cooler Outlet Pipe Replacement (9T50 / 9T60)
- Transmission Fluid Cooler Inlet and Outlet Pipe Replacement (AF50-8)
READ NEXT:
Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and
Connection
Removal Procedure
1.
Pull the plastic cap(1) back from the quick connect fitting (2)and down along
the cooler pipe enough
to expose the transmission fluid cooler pipe fitting retainer.
2.
Using a
Transmission Fluid Cooler Inlet Pipe Replacement (9T50 / 9T60)
Removal Procedure
1. Place a suitable container under the vehicle to catch any spilled
transmission fluid.
2. Front Wheelhouse Liner-Left Side - Remove.
3. Front Compartment Splash Shield-Right Sid
Transmission Fluid Cooler Outlet Pipe Replacement (9T50 / 9T60)
Removal Procedure
1. Place a suitable container under the vehicle to catch any spilled
transmission fluid.
2.
NOTE: Cover or plug all open transmission fluid cooler pipe connection
points
to help
SEE MORE:
Rear Suspension Lower Trailing Link Replacement
Removal Procedure
1. Raise and support the vehicle.
2. Remove the rear tire and wheel assembly.
3.
Rear Suspension Trailing Arm Nut(1) - Remove.
4. Rear Suspension Trailing Arm Bolt(2) - Remove and DISCARD.
5.
Rear Suspension Trailing Arm Bolt(1) - Remove and DISCARD.
6.
Rear Suspension Lowe
Wipers and Washers
SPECIFICATIONS
FASTENER SPECIFICATIONS
Reusable Threaded Fastener Tightening Specifications
NOTE:
All fasteners listed in this table can be reused after removal.
SCHEMATIC WIRING DIAGRAMS
WIPER/WASHER WIRING SCHEMATICS
Controls
Wipers
Washers
© 2019-2026 Copyright www.buregal6.com
