Buick Regal Owners & Service Manuals

Buick Regal: DTC P0703

Diagnostic Instructions

  • Perform the Diagnostic System Check prior to using this diagnostic procedure:Diagnostic System Check - Vehicle
  • Review the description of Strategy Based Diagnosis:Strategy Based Diagnosis
  • An overview of each diagnostic category can be found here:Diagnostic Procedure Instructions

DTC Descriptor

DTC P0703

Brake Switch Signal Message Counter Incorrect

Circuit/System Description

  • For an overview of the component/system, refer to:Cruise Control Description and Operation (Without Adaptive Cruise Control) or Cruise Control Description and Operation (With Adaptive Cruise Control)
  • The K9 sends a serial data message to the K20 indicating the B22 function that has been requested.

Conditions for Running the DTC

  • Ignition/Vehicle=On
  • Vehicle Speed.=Greater than 40 km/h (25 MPH)
  • Cruise Control=On

Frequency the DTC runs=Continuously - After the running conditions are met - For greater than 5 s

Conditions for Setting the DTC

Brake Pedal Position Sensor Signal=Invalid Serial Data

Actions Taken When the DTC Sets

  • Cruise Control System Status=Disabled
  • DTCs listed in the DTC Descriptor Category=Type C DTC

Conditions for Clearing the DTC

DTCs listed in the DTC Descriptor Category=Type C DTC

Reference Information

Schematic Reference

Cruise Control Wiring Schematics

Connector End View Reference

Component Connector End View Index

Electrical Information Reference

  • Circuit Testing
  • Connector Repairs
  • Testing for Intermittent Conditions and Poor Connections
  • Wiring Repairs

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Scan Tool Reference

Control Module References

Circuit/System Verification

1. Ignition - On / Vehicle - In Service Mode.

2. Verify there are no other DTCs set, except for DTC P0703.

  • If any other DTCs are set
  • Refer to:Diagnostic Trouble Code (DTC) List - Vehicle
  • Go to next step: If no other DTCs are set

3. Replace the component:K9 Body Control Module.

4. Operate the vehicle within the Conditions for Running the DTC. - Verify the DTC does not set.

  • If DTC P0703 is set
  • Replace the component:K20 Engine Control Module
  • Go to next step: If the DTC is not set

5. All OK.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the repair: Diagnostic Repair Verification.

For control module replacement, programming, and setup refer to: Control Module References.

    READ NEXT:

     DTC P1553

    Diagnostic Instructions Perform the Diagnostic System Check prior to using this diagnostic procedure:Diagnostic System Check - Vehicle Review the description of Strategy Based Diagnosis:Strategy

     DTC P158A

    Diagnostic Instructions Perform the Diagnostic System Check prior to using this diagnostic procedure:Diagnostic System Check - Vehicle Review the description of Strategy Based Diagnosis:Strategy

     Symptoms - Cruise Control

    NOTE: The following steps must be completed before using the symptom tables. 1. Before using the symptom diagnostic table, perform the Diagnostic System Check - Vehicle in order to verify the follow

    SEE MORE:

     DTC C1230 or C1231

    Diagnostic Instructions Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Review Strategy Based Diagnosis for an overview of the diagnostic approach. Diagnostic Procedure Instructions provide an overview of each diagnostic category. DTC Descriptors DT

     Curves in the Road

    Warning: On curves, ACC may not detect a vehicle ahead in your lane. You could be startled if the vehicle accelerates up to the set speed, especially when following a vehicle exiting or entering exit ramps. You could lose control of the vehicle or crash. Do not use ACC while driving on an entrance o

    © 2019-2024 Copyright www.buregal6.com