Buick Regal 2018-2026 Service Manual / Engine / Engine Mechanical - 2.0L (LTG)
Buick Regal: Engine Mechanical - 2.0L (LTG)
- Specifications
- Schematic Wiring Diagrams, Component Locator
- Diagnostic Information and Procedures
- Repair Instructions - On Vehicle
- Repair Instructions - Off Vehicle
- Description and Operation
- Special Tools and Equipment
READ NEXT:
Specifications
FASTENER SPECIFICATIONS
Single Use Non-Threaded Fasteners/Components
Application
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced
with NEW
after removal.
Camshaft Co
Schematic Wiring Diagrams, Component Locator
Schematic Wiring Diagrams
ENGINE OIL LEVEL AND PRESSURE CONTROL SCHEMATIC WIRING DIAGRAM (LTG)
Component Locator
DISASSEMBLED VIEWS
Camshaft Cover and Components
Engine Coolant Air Bleed Pipe Bolt
SEE MORE:
DTC B1025-B1135 (UQ3 without NKC)
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Refer to Diagnostic Procedure Instructions for an overview of each
diagnostic category.
DTC Descripto
Lumbar Adjustment
Four-Way Shown, Two-Way
Similar
To adjust the lumbar support,
if equipped:
Press and hold the front or rear
of the control to increase or
decrease lumbar support.
If equipped, press and hold the
top or bottom of the control to
raise or lower lumbar support.
Back Bolster Adjustment
To adjus
© 2019-2026 Copyright www.buregal6.com
