Buick Regal 2018-2026 Service Manual / HVAC & Restraints / HVAC - Automatic
Buick Regal: HVAC - Automatic
SPECIFICATIONS
FASTENER TIGHTENING TORQUE SPECIFICATIONS
Reusable Threaded Fastener Tightening Specifications
NOTE: All fasteners listed in this table can be reused after removal.
.png)
SCHEMATIC WIRING DIAGRAMS
HVAC WIRING SCHEMATICS
HVAC Module Power, Ground, Serial Data, and Subsystem References
.png)
HVAC Controls
.png)
A/C Compressor Controls
.png)
Blower Motor
.png)
Mode and Temperature Door Actuators
.png)
Temperature Sensors
.png)
Windshield and Sunload Sensors
.png)
Heater Coolant Pump
.png)
READ NEXT:
Diagnostic Information and Procedures
HVAC COMPONENT REPLACEMENT REFERENCE
DTC B0163
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diag
DTC B0163, B0183, or B1405
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diag
SEE MORE:
Forward Range Radar Module Inspection
Inspection Procedure
1.
CONTROL MODULE DTC CHECK - Using a scan tool, perform the Vehicle DTC
Information function - Verify there are no current control module DTCs set. If
any DTC is set, refer to Diagnostic Trouble Code (DTC) List - Vehicle.
2. Check the alignment of the forward range radar mod
Draining Fluids and Oil Filter Removal
1.
Remove the oil filter (1). Remove the oil pan drain plug and allow the oil to
drain out.
2. Clean the oil filter housing in the engine block.
CAUTION: Refer to Fastener Caution.
3. Install the oil pan drain plug and tighten to 25 N.m (18 lb ft).
4. If cleaning or repairing the engine block, i
© 2019-2026 Copyright www.buregal6.com
