Buick Regal: Repair Instructions
- Heater and Air Conditioning User Interface Control Replacement
- Inside Air Temperature Sensor Replacement - Left Side Upper
READ NEXT:
Heater and Air Conditioning User Interface Control Replacement
Preliminary Procedure
Instrument Panel Lower Trim Panel Replacement.
Heater and Air Conditioning User Interface Control Bolt[2x]
CAUTION:
Fastener Caution.
Tighten
2.5N.m (22 lb in)
Heater and
Inside Air Temperature Sensor Replacement - Left Side Upper
1. Instrument Panel Assembly - Remove.
2. Temperature Valve Actuator - Left Side - Remove.
3. Mode Control Cam Actuator - Remove.
4. Mode Control Cam Actuator Mounting Plate - Remove.
5.
Mode Val
Description and Operation
AUTOMATIC HVAC DESCRIPTION AND OPERATION
The air temperature and the air delivery description and operation are
divided into eight areas:
HVAC Control Components
Air Speed
Air Delivery
Heating a
SEE MORE:
Intake Manifold Installation
Special Tools
EN-45059 Angle Meter
EN-50790 HP Fuel Pump Installation Alignment Gauge
For equivalent regional tools, refer to Special Tools.
1.
Install a NEW gasket (1) on the intake manifold (3). Install the intake
manifold and hand start the intake
manifold bolts (2, 4).
2.
CAUTION: Refer
DTC B3435 or B3440
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diagnostic Procedure Instructions provides an overview of each
diagnostic category.
DTC Descriptor
DT
© 2019-2024 Copyright www.buregal6.com
