Buick Regal: Intermediate Steering Shaft Boot Replacement (Outer)
Special Tools
CH-804 Drive Axle Boot Clamp Pliers
Equivalent regional tools:Special Tools
Removal Procedure
1.
.png)
Intermediate Steering Shaft Inner Boot(1) - Remove.
2. Remove the front tire and wheel assembly.
3.
.png)
Cut the intermediate steering shaft outer boot clamp (1).
DISCARD the clamp.
4.
.png)
Slide the intermediate steering shaft outer boot (1) upwards to expose the intermediate steering shaft lower bolt.
5. Intermediate Steering Shaft Lower Bolt(2) - Remove.
6.
.png)
Remove the intermediate steering shaft (1) from the vehicle.
7. Remove the intermediate steering shaft outer boot (1) from the vehicle.
Installation Procedure
1.
.png)
Position a NEW intermediate steering shaft outer boot clamp (1) onto the intermediate steering shaft outer boot.
2. Position the intermediate steering shaft outer boot (1) on the vehicle.
3.
.png)
Position the intermediate steering shaft (1) in the vehicle.
4.
.png)
CAUTION: Refer to Fastener Caution.
Intermediate Steering Shaft Lower Bolt(2) - Install and tighten 42 N.m (31 lb ft).
- Clean the threads of the bolt and mating threads with denatured alcohol or equivalent and allow to dry.
- Apply thread locking adhesive to the bolt.
5. Slide the intermediate steering shaft outer boot (1) downwards and onto the steering gear.
6. Use the CH-804 pliers (1) to install the NEW intermediate steering shaft outer boot clamp.
7. Install the front tire and wheel assembly.
8.
.png)
Intermediate Steering Shaft Inner Boot(1) - Install.
READ NEXT:
Intermediate Steering Shaft Replacement
Special Tools
CH-804 Drive Axle Boot Clamp Pliers
Equivalent regional tools:Special Tools
Removal Procedure
1.
Intermediate Steering Shaft Inner Boot(1) - Remove.
2. Remove the front tire and wheel
Steering Column Accident Damage Inspection
Inspection Procedure
1. Turn Signal Switch Bracket Replacement - Remove.
CAUTION: Vehicles involved in accidents that result in any of the
following kinds
of damage or situations, may also have a dam
Steering Column Lower Trim Cover Replacement
Preliminary Procedure
Steering Column Upper Trim Cover Replacement.
Steering Column Lower Trim Cover Bolt[3x]
CAUTION: Refer to Fastener Caution.
Procedure
Extend the steering column to the
SEE MORE:
Securing Child Restraints (With
the Seat Belt in the
Rear Seat)
When securing a child restraint in a
rear seating position, study the
instructions that came with the child
restraint to make sure it is
compatible with this vehicle.
If the child restraint has the LATCH
system, see Lower Anchors and
Tethers for Children (LATCH
System) for how and where to
install
Exterior Lamp Controls
The exterior lamp control is on the
instrument panel to the left of the
steering column.
There are four positions.
: Turns the exterior lamps off and
deactivates the AUTO mode. Turn
to again to reactivate the
AUTO mode.
In Canada, the headlamps will
automatically reactivate when the
vehicle is
