Buick Regal 2018-2026 Service Manual / Steering & Driveline & Axle / Steering Wheel and Column / Repair Instructions
Buick Regal: Repair Instructions
- Wire to Wire Repair - Steering
- Connector Reconnection - Steering
- Upper Intermediate Steering Shaft Replacement
- Intermediate Steering Shaft Boot Replacement (Inner)
- Intermediate Steering Shaft Boot Replacement (Outer)
- Intermediate Steering Shaft Replacement
- Steering Column Accident Damage Inspection
- Steering Column Lower Trim Cover Replacement
- Steering Column Replacement
READ NEXT:
Wire to Wire Repair - Steering
Special Tools
EL-38125-10 Splice Sleeve Crimping Tool (non GMNA)
J-38125-5A Ultra Torch Special Tool
J-38125-8 Splice Sleeve Crimping Tool (GMNA)
For equivalent regional tools, refer to Special T
Connector Reconnection - Steering
Special Tools
EL-35616 Terminal Test Probe Kit
For equivalent regional tools, refer to Special Tools.
When the condition is not currently present, but is indicated in DTC history,
the cause may be in
Upper Intermediate Steering Shaft Replacement
Removal Procedure
1.
Upper Intermediate Steering Shaft Upper Bolt(1) - Remove.
2. Upper Intermediate Steering Shaft(2)@Steering Column - Separate.
3.
Release the upper intermediate steering shaft b
SEE MORE:
Forward Range Radar Module Inspection
Inspection Procedure
1.
CONTROL MODULE DTC CHECK - Using a scan tool, perform the Vehicle DTC
Information function - Verify there are no current control module DTCs set. If
any DTC is set, refer to Diagnostic Trouble Code (DTC) List - Vehicle.
2. Check the alignment of the forward range radar mod
Transmission Fluid Cooler Inlet and Outlet Pipe Replacement (AF50-8)
Removal Procedure
1.
Place a drain pan under the vehicle.
2. Transmission Fluid Cooler Pipe Connector Cap(1)@Radiator - Unclip.
3. Transmission Fluid Cooler Outlet Pipe(2)@Quick Connect Fitting - Disconnect.
4. Raise and support the vehicle.
5. Charge Air Cooler Inlet Air Tube - Remove.
6.
T
© 2019-2026 Copyright www.buregal6.com
