Buick Regal: Reclining Seatbacks
Warning: Sitting in a reclined position when the vehicle is in motion can be dangerous. Even when buckled up, the seat belts cannot do their job.
The shoulder belt will not be against your body. Instead, it will be in front of you. In a crash, you could go into it, receiving neck or other injuries.
The lap belt could go up over your abdomen. The belt forces would be there, not at your pelvic bones. This could cause serious internal injuries.
For proper protection when the vehicle is in motion, have the seatback upright. Then sit well back in the seat and wear the seat belt properly.
.png)
Do not have a seatback reclined if the vehicle is moving.
Manual Reclining Seatbacks
Warning: If either seatback is not locked, it could move forward in a sudden stop or crash. That could cause injury to the person sitting there.
Always push and pull on the seatbacks to be sure they are locked.
.png)
To recline a manual seatback:
1. Lift the lever.
2. Move the seatback to the desired position, and then release the lever to lock the seatback in place.
3. Push and pull on the seatback to make sure it is locked.
To return the seatback to the upright position:
1. Lift the lever fully without applying pressure to the seatback, and the seatback will return to the upright position.
2. Push and pull on the seatback to make sure it is locked.
Power Reclining Seatbacks
.png)
To adjust a power seatback, if available:
- Tilt the top of the control rearward to recline.
- Tilt the top of the control forward to raise.
READ NEXT:
Memory Seats
If equipped, memory seats allow two
drivers to save and recall their
unique seat positions for driving the
vehicle, and a shared exit position
for getting out of the vehicle. Other
feature positions
Heated and Ventilated Front
Seats
Warning:
If temperature change or pain to
the skin cannot be felt, the seat
heater may cause burns. To
reduce the risk of burns, use care
when using the seat heater,
especially for long periods of
tim
Rear Seats
Rear Seat Reminder
If equipped, the message REAR
SEAT REMINDER LOOK IN REAR
SEAT displays under certain
conditions indicating there may be
an item or passenger in the rear
seat. Check before exiting t
SEE MORE:
Engine Coolant Fan Wiring Harness Replacement (2.0L LTG)
Removal Procedure
1. Front Bumper Fascia Center Support - Remove.
2.
Clip (2) - Remove.
3. Disconnect the electrical connector. (1).
4.
Clip (1) - Remove [2x].
5.
Clip (1) - Remove.
6. Engine Coolant Fan Electrical Connector (2) - Disconnect [2x].
7.
Clip (1) - Remove [2x].
8.
Ground Cabl
Valve and Seat Grinding
Valve Measurement and Reconditioning Overview
Proper valve service is critical to engine performance. Therefore, all
detailed measurement procedures must be
followed to identify components that are out of specification.
If the measurement procedures reveal that the valve or valve seat must
b
