Buick Regal Owners & Service Manuals
Buick Regal 2018-2025 Owners Manual / Instruments and Controls / Controls / Steering Wheel Adjustment

Buick Regal: Steering Wheel Adjustment

To adjust the steering wheel:

To adjust the steering wheel:

1. Pull the lever down.

2. Move the steering wheel up or down.

3. Pull or push the steering wheel closer or away from you.

4. Pull the lever up to lock the steering wheel in place.

Do not adjust the steering wheel while driving.

Steering Wheel Controls

The infotainment system can be operated by using the steering wheel controls. See "Steering Wheel Controls" in the infotainment manual.

Heated Steering Wheel

: If equipped, press to turn on

or : If equipped, press to turn on or off. A light near the button displays when the feature is turned on.

The steering wheel takes about three minutes to start heating.

Horn

Press to sound the horn. on the steering wheel pad to sound the horn.

    READ NEXT:

     Windshield Wiper/Washer

    With the ignition on or in ACC/ ACCESSORY, move the windshield wiper lever to select the wiper speed. HI : Use for fast wipes. LO : Use for slow wipes. INT : Use for intermittent wipes. To adjust

     Rear Window Wiper/ Washer

    If equipped, the ignition must be on or in ACC/ACCESSORY to operate the rear window wiper/washer. Turn the end of the windshield wiper lever to operate the rear window wiper/washer. OFF : Turns the

     Power Outlets

    Power Outlets 12-Volt Direct Current The 12-volt power outlets can be used to plug in electrical equipment, such as a cell phone or MP3 player. The vehicle may have accessory power outlets: Below t

    SEE MORE:

     Instrument Panel

    Instrument Panel Overview Air Vents Turn and Lane-Change Signals Instrument Cluster Driver Information Center (DIC) Display Windshield Wiper/Washer Hazard Warning Flashers Light Sensor Infotainment Traction Control/Electronic Stability Control Dual Automatic Climate Control System

     Symptoms - Cruise Control

    NOTE: The following steps must be completed before using the symptom tables. 1. Before using the symptom diagnostic table, perform the Diagnostic System Check - Vehicle in order to verify the following conditions: There are no DTCs set. The module can communicate via the serial data. 2. Review

    © 2019-2025 Copyright www.buregal6.com