Buick Regal Owners & Service Manuals

Buick Regal: DTC C0475

Diagnostic Instructions

  • Perform the Diagnostic System Check prior to using this diagnostic procedure:Diagnostic System Check - Vehicle
  • Review the description of Strategy Based Diagnosis:Strategy Based Diagnosis
  • An overview of each diagnostic category can be found here:Diagnostic Procedure Instructions

DTC Descriptor

DTC C0475

Power Steering Motor Circuit

Symptom Byte Information: Symptom Byte List.

Circuit/System Description

For an overview of the component/system, refer to:Power Steering System Description and Operation (Electronic Power Steering).

Conditions for Running the DTC

Ignition = On

Conditions for Setting the DTC

Power Steering Motor Circuit = Malfunction

Actions Taken When the DTC Sets

  • Power Steering Output Torque = Disabled
  • P9 Driver Information Center Display = Service Power Steering

Conditions for Clearing the DTC

  • A current DTC will clear on the next malfunction-free ignition cycle.
  • A history DTC will clear after 40 consecutive malfunction-free ignition cycles.

Reference Information

Schematic Reference

Power Steering Wiring Schematics

Connector End View Reference

COMPONENT CONNECTOR END VIEW INDEX

Electrical Information Reference

  • Circuit Testing
  • Connector Repairs
  • Testing for Intermittent Conditions and Poor Connections
  • Wiring Repairs

Scan Tool Reference

Control Module References

Circuit/System Verification

1. Ignition - On / Vehicle - In Service Mode.

2. Verify DTC C0475 is not set.

  • If the DTC is set
  1. Clear DTCs - DTC C0475
  2. Cycle the ignition from OFF to ON.
  3. Verify the DTC does not set.
    • If the DTC sets - Replace the component: Steering Gear
    • Go to next step: If the DTC does not set
  • Go to next step: If the DTC is not set

3. All OK.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the repair: Diagnostic Repair Verification

Electric Dual Pinion Rack and Pinion Steering Gear Replacement

For control module replacement, programming, and setup refer to: Control Module References.

    READ NEXT:

     DTC C047A

    Diagnostic Instructions Perform the Diagnostic System Check prior to using this diagnostic procedure:Diagnostic System Check - Vehicle Review the description of Strategy Based Diagnosis:Strategy

     DTC C0545

    Diagnostic Instructions Perform the Diagnostic System Check prior to using this diagnostic procedure:Diagnostic System Check - Vehicle Review the description of Strategy Based Diagnosis:Strategy

     DTC C0569

    Diagnostic Instructions Perform the Diagnostic System Check prior to using this diagnostic procedure:Diagnostic System Check - Vehicle Review the description of Strategy Based Diagnosis:Strategy

    SEE MORE:

     DTC B392C

    Diagnostic Instructions Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Review Strategy Based Diagnosis for an overview of the diagnostic approach. Diagnostic Procedure Instructions provides an overview of each diagnostic category. DTC Descriptors D

     Special Tools and Equipment

    SPECIAL TOOLS DT-45866 J-45866 Input Shaft Seal Installer EN-8062 J-8062 KM-348 Valve Spring Compressor - Head Off EN-8087 J-8087 Cylinder Bore Gauge EN-21867-850 J-21867-850 KM-498-B KM-6106 83 93 852 Oil Pressure Gauge Adapter EN-22738-B GE-22738-B J-22738-B J-9666 Valve Spring Tester EN-2395

    © 2019-2026 Copyright www.buregal6.com