Removal Procedure
1. Prepare the control module for removal using the SPS programming support
tool.
NOTE: The rear differential clutch control module can now be removed
and replaced.
2. Raise and su
1. Raise and support the vehicle.
2. Clean the area around the rear axle fill plug.
3. Place a drain pan under the vehicle.
4.
Differential Clutch Cover Plug(1) - Remove.
5. Rear Axle Housing Fi
Tools Required
J-45725 Cradle Bushing Replacer
For equivalent regional tool, refer to Special Tools.
Removal Procedure
1. Raise and support the vehicle.
2. Remove the rear differential assembly.
3
Removal Procedure
1. Remove the tire and wheel assembly.
WARNING: To prevent personal injury and/or component damage, do not
allow the weight
of the vehicle to load the front wheels, or attempt to operate the vehicle, when
the wheel drive shaft(s) or wheel drive shaft nut(s) are removed. To do so m
Diagnostic Instructions
Perform the Diagnostic System Check prior to using this diagnostic
procedure: Diagnostic
System Check - Vehicle
Review the description of Strategy Based Diagnosis: Strategy Based
Diagnosis
An overview of each diagnostic category can be found here: Diagnostic
Proced