Buick Regal 2018-2026 Service Manual / Transmission / Automatic Transmission - Aisin AF50-8 (MRC) / Repair Instructions - On Vehicle
Buick Regal: Repair Instructions - On Vehicle
- Gear Selector -N- Position Learn
- Connector Reconnection - Automatic Transmission
- Range Selector Lever Cable Replacement
- Range Selector Lever Cable Adjustment
- Transmission Control Lever Knob Replacement
- Vent Hose Replacement
- Input Speed Sensor Replacement
- Front Wheel Drive Shaft Seal Replacement - Left Side
- Wiring Harness Wire Replacement
READ NEXT:
Gear Selector -N- Position Learn
Diagnostic Instructions
Perform the Diagnostic System Check prior to using this diagnostic
procedure: Refer to Diagnostic System
Check - Vehicle
Review the description of Strategy Based Diagnosi
Connector Reconnection - Automatic Transmission
Special Tools
EL-35616 Terminal Test Probe Kit
For equivalent regional tools, refer to Special Tools.
When the condition is not currently present, but is indicated in DTC history,
the cause may be in
Range Selector Lever Cable Replacement
Removal Procedure
1. Battery Tray - Remove - Refer to Battery Tray Replacement.
2.
Range Selector Lever Cable (4) @Range Selector Lever Cable Lever (3) -
Remove.
3. Range Selector Lever Cable@Trans
SEE MORE:
DTC B3902
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diagnostic Procedure Instructions provides an overview of each
diagnostic category.
DTC Descriptor
DT
Transfer Case Bracket Replacement (2.0L LTG)
Removal Procedure
1. Raise and support the vehicle. Lifting and Jacking the Vehicle.
NOTE: The drive shaft remains in the wheel hub.
2. Front Wheel Drive Half Shaft- Right Side@Transfer Case - Disconnect.
3.
Remove the 2 transfer case bracket to transfer case bolts (1).
4.
Transfer Case Bracket
© 2019-2026 Copyright www.buregal6.com
